
Emergency Furnace Repair
No heat in a cold snap: frosted vents, frozen condensate lines, failed igniters and inducer motors, fixed or made safe first.

West Edmonton · T5M
No-heat repairs, tune-ups, furnace replacement, air conditioning, heat pumps and hot water tanks for Westmount homes, with the diagnosis explained and the price in writing before work starts.
Heating in Westmount
Westmount holds homes from the 1910s to the 1950s, including the Westmount Architectural Heritage Area, with the shops of 124 Street close by. Character houses and 1950s bungalows share the same blocks.

Working the area
Service calls around Westmount Architectural Heritage Area and 124 Street shops, and the streets between.
Westmount mixes two housing eras, and a furnace visit starts by working out which one you are standing in. The older houses, including those in the Westmount Architectural Heritage Area, date from the 1910s to the 1940s and were heated by coal or gravity systems before forced air arrived. The 1950s bungalows were built with chimney-vented furnaces that have since been replaced at least once. Both end up in the same place at the next replacement: a high-efficiency furnace venting through PVC in the side wall, and a gas hot water tank still drafting up a chimney sized for two appliances. A tank in that position can fail to draft and spill exhaust into the basement, so the quote should cover a liner, a power-vent tank or re-venting before the new furnace is fired.
In the bungalows, the other common issue is a finished basement. Ducts got boxed into bulkheads, return grilles ended up behind a couch or were drywalled over, and the furnace now runs hot and loud because it cannot pull enough air. Opening a return path often does more for comfort than a bigger furnace. Once the vents are PVC, check where they exit: on a narrow lot, snow sliding off a neighbour's roof can bury them.
What We See Most
The patterns behind most Westmount service calls, given the age of the homes and how they were built.
1910s to 1940s houses with ductwork added after coal or gravity heat
1950s bungalows whose original chimney-vented furnaces were replaced once already
Orphaned natural-draft hot water tanks after a switch to high-efficiency venting
Basement renovations that boxed in ducts and blocked returns
Something else in Westmount?
A furnace that short-cycles, a noisy blower, an HRV that froze, a hot water tank that runs out fast: tell us what it is doing and when it started.
Send a requestServices in Westmount

No heat in a cold snap: frosted vents, frozen condensate lines, failed igniters and inducer motors, fixed or made safe first.

A real tune-up before winter: combustion test, flame sensor, igniter, pressure switch, condensate trap, filter and vents.

Swapping a tired furnace for a 95–98% unit, including the chimney and hot water tank venting questions older homes raise.

High-efficiency furnaces sized from a heat loss calculation, vented right for snow, with the gas permit and inspection.

Capacitors, contactors, refrigerant leaks and frozen coils on the few hot weeks a year you actually need the AC.

Hot water tank repair and replacement: gas, power-vent and tankless, with sediment, venting and the gas permit handled.
Before We Arrive
Some no-heat calls end at step one. The rest go faster when we know what the furnace did before it stopped.
Thermostat set to heat and above room temperature, batteries, the furnace switch and breaker, and a filter that isn't grey and bowed.
From outside, find the two white PVC pipes. Snow drifted over them or a ring of frost inside is the most common cold-snap shutdown.
Count the flashes on the board through the sight glass on the blower door. The chart is inside the door. It saves diagnostic time.
Community, furnace age if you know it, what it's doing and the blink code. We reply with an arrival window for Westmount.
Tell us what the furnace is doing. We reply with an arrival window and a price range, and the price is confirmed in writing before any work starts.
Nearby Communities
Character homes by the river valley, 1950s bungalows and 1970s suburbs out to the Henday.
All Service AreasPermits & Safety
Westmount Questions
Straight answers on timing, local failure patterns, cost and permits.
All QuestionsNo-heat calls get priority, and typical drive time to Westmount is around 25 minutes from wherever the technician is working. We confirm the arrival window when we reply to your request rather than promise a time we can't keep. While you wait, check the thermostat, the furnace switch and breaker, the filter, and the two PVC vent pipes outside for snow or frost.
The pattern we see most in Westmount is 1910s to 1940s houses with ductwork added after coal or gravity heat, followed by 1950s bungalows whose original chimney-vented furnaces were replaced once already. Westmount holds homes from the 1910s to the 1950s, including the Westmount Architectural Heritage Area, with the shops of 124 Street close by. Character houses and 1950s bungalows share the same blocks. Cold snaps stress every furnace in the region, so frosted vents, frozen condensate lines and worn igniters show up in every community.
Typical Edmonton ranges apply in Westmount: a diagnostic visit runs $129 to $199 in regular hours and $199 to $349 after hours. Common parts include an igniter at $225 to $450, a flame sensor at $129 to $299 and an inducer motor at $650 to $1,400. A new high-efficiency furnace, installed, typically runs $4,800 to $7,500 for a single-stage unit. Your price is confirmed in writing before any work starts.
Yes. Replacing a gas furnace or a gas hot water tank needs a gas permit through the City of Edmonton, and an inspection after the work. The contractor pulls the permit; gas work in Alberta is done by a certified gasfitter. Ask to see the permit number on your quote or invoice.
No-heat calls get priority. We reply with the arrival window for Westmount and a price range, and nothing is done without your OK in writing.