
Emergency Furnace Repair
No heat in a cold snap: frosted vents, frozen condensate lines, failed igniters and inducer motors, fixed or made safe first.

St. Albert, Spruce Grove & Stony Plain · T8R
No-heat repairs, tune-ups, furnace replacement, air conditioning, heat pumps and hot water tanks for Morinville homes, with the diagnosis explained and the price in writing before work starts.
Heating in Morinville
Morinville is a town north of St. Albert on Highway 2, with its own permit process. Much of its housing is in newer subdivisions with high-efficiency equipment.

Working the area
Service calls around Highway 2 and St. Albert, and the streets between.
Morinville sits north of St. Albert on Highway 2, at the longer end of our travel area, which is one more reason to do the quick checks before booking a no-heat visit. Most of the town's homes are from the newer building years, with high-efficiency furnaces vented through PVC pipes on the side wall. After a snowfall with wind behind it, drifts can bury those pipes on the exposed side of a house. The furnace starts, the inducer spins, the pressure switch never closes, and after a few tries the unit locks out and flashes a code. Clearing the snow by hand, then switching the furnace off for a minute and back on, often gets the heat going.
If it locks out again, stop there and book the visit. Condensate lines that run near a cold wall are the second winter culprit. HRVs in these homes need their filters and core cleaned, and a frozen HRV in a cold snap is common. Replacements here go through Morinville's own permit process rather than Edmonton's, and the contractor pulls the gas permit and arranges the inspection. The builder-grade furnaces in the earliest of the newer subdivisions are reaching the age where a repair-or-replace comparison is worth asking for.
What We See Most
The patterns behind most Morinville service calls, given the age of the homes and how they were built.
Side-wall PVC vents buried by drifting snow on exposed sides of the house
Frozen condensate lines in cold snaps
HRV cores freezing and filters clogging
Power-vented and tankless water heaters needing service
Builder-grade furnaces in the earliest newer subdivisions reaching repair-or-replace age
Something else in Morinville?
A furnace that short-cycles, a noisy blower, an HRV that froze, a hot water tank that runs out fast: tell us what it is doing and when it started.
Send a requestServices in Morinville

No heat in a cold snap: frosted vents, frozen condensate lines, failed igniters and inducer motors, fixed or made safe first.

A real tune-up before winter: combustion test, flame sensor, igniter, pressure switch, condensate trap, filter and vents.

Swapping a tired furnace for a 95–98% unit, including the chimney and hot water tank venting questions older homes raise.

High-efficiency furnaces sized from a heat loss calculation, vented right for snow, with the gas permit and inspection.

Capacitors, contactors, refrigerant leaks and frozen coils on the few hot weeks a year you actually need the AC.

Hot water tank repair and replacement: gas, power-vent and tankless, with sediment, venting and the gas permit handled.
Before We Arrive
Some no-heat calls end at step one. The rest go faster when we know what the furnace did before it stopped.
Thermostat set to heat and above room temperature, batteries, the furnace switch and breaker, and a filter that isn't grey and bowed.
From outside, find the two white PVC pipes. Snow drifted over them or a ring of frost inside is the most common cold-snap shutdown.
Count the flashes on the board through the sight glass on the blower door. The chart is inside the door. It saves diagnostic time.
Community, furnace age if you know it, what it's doing and the blink code. We reply with an arrival window for Morinville.
Tell us what the furnace is doing. We reply with an arrival window and a price range, and the price is confirmed in writing before any work starts.
Nearby Communities
Furnace repair and heat pump work north-west and west of the city, each town with its own permits.
All Service AreasPermits & Safety
Morinville Questions
Straight answers on timing, local failure patterns, cost and permits.
All QuestionsNo-heat calls get priority, and typical drive time to Morinville is around 30 minutes from wherever the technician is working. We confirm the arrival window when we reply to your request rather than promise a time we can't keep. While you wait, check the thermostat, the furnace switch and breaker, the filter, and the two PVC vent pipes outside for snow or frost.
The pattern we see most in Morinville is side-wall PVC vents buried by drifting snow on exposed sides of the house, followed by frozen condensate lines in cold snaps. Morinville is a town north of St. Albert on Highway 2, with its own permit process. Much of its housing is in newer subdivisions with high-efficiency equipment. Cold snaps stress every furnace in the region, so frosted vents, frozen condensate lines and worn igniters show up in every community.
Typical Edmonton ranges apply in Morinville: a diagnostic visit runs $129 to $199 in regular hours and $199 to $349 after hours. Common parts include an igniter at $225 to $450, a flame sensor at $129 to $299 and an inducer motor at $650 to $1,400. A new high-efficiency furnace, installed, typically runs $4,800 to $7,500 for a single-stage unit. Your price is confirmed in writing before any work starts.
Yes. Replacing a gas furnace or a gas hot water tank needs a gas permit through the Town of Morinville or its accredited agency, and an inspection after the work. The contractor pulls the permit; gas work in Alberta is done by a certified gasfitter. Ask to see the permit number on your quote or invoice.
No-heat calls get priority. We reply with the arrival window for Morinville and a price range, and nothing is done without your OK in writing.