Emergency Furnace Repair
No heat in a cold snap: frosted vents, frozen condensate lines, failed igniters and inducer motors, fixed or made safe first.
Central Edmonton · T6G
Furnace Repair in Garneau
No-heat repairs, tune-ups, furnace replacement, air conditioning, heat pumps and hot water tanks for Garneau homes, with the diagnosis explained and the price in writing before work starts.
- Typical drive around 20 minutes
- No-heat calls prioritized
- Price in writing before any work
- ~20 min Typical drive to Garneau
- T6G Postal code area
- ~95 yrs Typical home age
- 15–20 Years most furnaces last
Heating in Garneau
What Fails in Garneau, and Why
Garneau sits next to the University of Alberta and the west end of Whyte Avenue. Its early 1900s houses include many rentals and conversions, with modern infill going up beside them.
Working the area
Service calls around University of Alberta and Whyte Avenue (west end), and the streets between.
Notes from Garneau service calls
Garneau is a landlord's neighbourhood as much as an owner's. With the University of Alberta next door, a lot of the early 1900s houses are rentals or have been split into units, and the heating in them tends to be whatever was cheapest to keep running. The no-heat calls follow that pattern: a filter that has not been changed since the last tenant moved in, a limit switch tripping because the furnace cannot push air through a clogged filter and ducts that were never big enough, a flame sensor so coated that the burners light and drop out three times before the furnace locks out. Those are cheap fixes, and on a furnace under 15 years old they are the right fix. Older units in these basements are a different conversation, particularly when an inspection turns up a cracked heat exchanger.
Replacement here is rarely a straight swap. The original chimney usually serves the hot water tank too, basements are tight with low ceilings, and some homes still run a boiler and radiators. Infill houses built beside the old ones bring high-efficiency furnaces and PVC vents into side yards only a few feet wide, where snow piles up fast. Tenants can describe the symptoms, but the written quote goes to the owner.
What We See Most
Common Heating Problems in Garneau
The patterns behind most Garneau service calls, given the age of the homes and how they were built.
-
Furnaces in rental houses and conversions that were patched rather than maintained
-
Undersized ductwork and returns added to houses first heated by coal or gravity
-
Shared chimneys and orphaned hot water tanks after a high-efficiency furnace swap
-
Hot water boilers and radiators in some older homes
-
Side-wall PVC vents on infill homes drifting over in narrow side yards
Something else in Garneau?
A furnace that short-cycles, a noisy blower, an HRV that froze, a hot water tank that runs out fast: tell us what it is doing and when it started.
Send a request
Services in Garneau
Every Service, Same Written Price
Furnace Maintenance and Tune-Up
A real tune-up before winter: combustion test, flame sensor, igniter, pressure switch, condensate trap, filter and vents.
Furnace Replacement
Swapping a tired furnace for a 95–98% unit, including the chimney and hot water tank venting questions older homes raise.
Furnace Installation
High-efficiency furnaces sized from a heat loss calculation, vented right for snow, with the gas permit and inspection.
Air Conditioner Repair
Capacitors, contactors, refrigerant leaks and frozen coils on the few hot weeks a year you actually need the AC.
Water Heater Repair and Replacement
Hot water tank repair and replacement: gas, power-vent and tankless, with sediment, venting and the gas permit handled.
Before We Arrive
Four Things Worth Doing First
Some no-heat calls end at step one. The rest go faster when we know what the furnace did before it stopped.
Step 1: Check the Basics
Thermostat set to heat and above room temperature, batteries, the furnace switch and breaker, and a filter that isn't grey and bowed.
Step 2: Look at the Vents
From outside, find the two white PVC pipes. Snow drifted over them or a ring of frost inside is the most common cold-snap shutdown.
Step 3: Read the Blink Code
Count the flashes on the board through the sight glass on the blower door. The chart is inside the door. It saves diagnostic time.
Step 4: Send the Request
Community, furnace age if you know it, what it's doing and the blink code. We reply with an arrival window for Garneau.
Furnace Repair in Garneau
Tell us what the furnace is doing. We reply with an arrival window and a price range, and the price is confirmed in writing before any work starts.
Nearby Communities
Also Covering Central Edmonton
Towers, character homes and the oldest heating systems in the city.
All Service AreasPermits & Safety
What to know before any gas work in Garneau
- Permits in Garneau A furnace or hot water tank replacement needs a gas permit through the City of Edmonton, followed by an inspection. The contractor pulls it.
- Door-to-door offers Alberta banned door-to-door sales of furnaces, air conditioners and hot water tanks on 1 March 2019. Anyone knocking with a furnace deal is already breaking the rule.
- Gas smell or CO alarm Get out first, don't touch switches or the thermostat, and call ATCO Gas's 24-hour emergency line or 911 from outside. Book the repair after.
Garneau Questions
What Garneau Homeowners Ask
Straight answers on timing, local failure patterns, cost and permits.
All QuestionsHow quickly can you get to a no-heat call in Garneau?
No-heat calls get priority, and typical drive time to Garneau is around 20 minutes from wherever the technician is working. We confirm the arrival window when we reply to your request rather than promise a time we can't keep. While you wait, check the thermostat, the furnace switch and breaker, the filter, and the two PVC vent pipes outside for snow or frost.
What furnace and HVAC problems are most common in Garneau?
The pattern we see most in Garneau is furnaces in rental houses and conversions that were patched rather than maintained, followed by undersized ductwork and returns added to houses first heated by coal or gravity. Garneau sits next to the University of Alberta and the west end of Whyte Avenue. Its early 1900s houses include many rentals and conversions, with modern infill going up beside them. Cold snaps stress every furnace in the region, so frosted vents, frozen condensate lines and worn igniters show up in every community.
What does furnace repair cost in Garneau?
Typical Edmonton ranges apply in Garneau: a diagnostic visit runs $129 to $199 in regular hours and $199 to $349 after hours. Common parts include an igniter at $225 to $450, a flame sensor at $129 to $299 and an inducer motor at $650 to $1,400. A new high-efficiency furnace, installed, typically runs $4,800 to $7,500 for a single-stage unit. Your price is confirmed in writing before any work starts.
Does a furnace replacement in Garneau need a permit?
Yes. Replacing a gas furnace or a gas hot water tank needs a gas permit through the City of Edmonton, and an inspection after the work. The contractor pulls the permit; gas work in Alberta is done by a certified gasfitter. Ask to see the permit number on your quote or invoice.
No Heat in Garneau? Tell Us What It's Doing.
No-heat calls get priority. We reply with the arrival window for Garneau and a price range, and nothing is done without your OK in writing.
